Every Step in Canning

Angebote / Angebote:

Excerpt: ... will thoroughly dissolve. The flux is always best when it has stood from twelve to sixteen hours before using. Strain through a piece of cloth or muslin. Dilute with a little water, about half and half. This will make the soldering flux. When using keep the flux well mixed and free from dust and dirt. Tinning Capping Iron. Purchase five or ten cents worth of sal ammoniac at the drug store, clean iron with file or knife. Mix a little solder with the sal ammoniac. Heat the capping iron hot enough so that it will melt the solder and convert it into a liquid. Place the iron in the vessel containing the mixture of sal ammoniac and solder. Rotate iron in the mixture until the soldering edge of the iron has become bright or thoroughly covered with the solder. All particles of smudge, burned material, and so forth, should be removed from the iron before tinning. Tinning the Tipping Copper. The tipping copper is tinned in very much the same way as the iron. Sometimes it is desirable to file the tipping copper a bit so as to make it smooth and to correct the point. Heat the copper and rotate the tip of it in the mixture of sal ammoniac and lead until it has been covered with the melted lead and is bright as silver. The copper should be filed nearly to a sharp point. Capping a Tin Can. Use one tin can for experimenting. By capping and tipping, heating the cap, and throwing it off and simply putting another cap on the same can, you can use this one can until you become proficient in capping. When capping the full packs arrange the cans in rows upon the table while the capping and tipping irons are heating in the fire. Take a handful of solder-hemmed caps and place them on all cans ready to be capped. Place a finger on the vent hole, hold cap in place, and run the brush containing a small amount of flux evenly round the solder-hemmed cap with one stroke of the hand. Do this with all cans ready to be capped. Then take the capping iron from the fire. Insert in...